How To Hang And Wire Your Ceiling Fan - Fanimation EMBRACE FPS7955B Manual

Hide thumbs

Table Of Contents

Table of Contents

Available languages

WARNING

The fan must be hung with at least 7´ of clearance from

floor to blades. (Figure 1)

WARNING

To avoid possible electrical shock, be sure electricity is

turned off at the main fuse box before hanging.

NOTE: If you are not sure if the outlet box is grounded,

contact a licensed electrician for advice, as it must be

grounded for safe operation.

WARNING

It is critical that the outlet box and the screws are

securely anchored to the building structure and capable

of withstanding a load of at least 35 lbs. Failure to verify

that the screws are properly installed could result in the

fan falling. (Figure 2)

" x 2" lag bolt and flat washer, attach

1. Using the /

3 8

safety cable to ceiling joist or wood structural member.

The lag bolt will pass through the flat washer, safety

cable loop, and into the building structure (Figure 2). You

will first drill a ¼ " pilot hole into the building structure to

prevent splitting or cracking.

2. The ceiling support cable need to through the center

hole of ceiling bracket when mounting. Using the two

#8-32 screws securely attach the ceiling bracket gasket

and ceiling bracket to ceiling junction box as shown.

(Figure 2)

3. Attach the safety cable to ceiling support cable.

Slide cable clamp onto safety cable (from fan). Place

the end of cable through the loop of ceiling support

cable. Pull asmuch cable through loop as possible.

Feed end of cable into clamp hole and firmly tighten

screw (Figure 3). Cut off excess safety cable.

4. Make sure the electrical supply wires, including the

ceiling bracket grounding wire and safety cable are

pulled through the downrod, between the ceiling

bracket and the junction box so that electrical

connections can bemade later.