Citizen Eco-Drive E76 Instruction Manual page 30

3. Once each hand has been aligned at the 12:00 position and the date has been
aligned at "1", return the crown to the 0 position (normal position).
Note (1): It takes about 1 second for the watch to store the reference position
in memory. Once the reference position has been stored in memory,
the second hand will begin irregular two-second interval movement.
The reference position may not be stored in memory if the crown is
operated before the start of irregular two-second interval movement
after returning the crown to the normal position.
(2):The second hand will continue to remain stopped even if the crown is
returned to the normal position unless the reference position alignment
procedure is performed.
4. After performing the reference position alignment procedure, properly reset the
time and date.
* The watch shows 12:00 AM after reference position alignment has been
performed. Set the time and date by referring to "3. Setting the Time and Date"
while paying attention to AM and PM.
29