Toro TX 1000 Compact Tool Carrier Installation Instructions And Technical Information page 4

Figure 7
1. Drive sprocket
2. Track
3. Front wheel
4. Rear bolt
4. Loosen the rear bolt, near the drive wheel
Note: This enables the drive wheel to pivot forward
and release the tension of the track. If it does not
pivot, turn on the engine and briefly move the traction
control forward.
5. Remove the track at the top of the front wheel, peeling
it off the wheel while rotating the track forward.
6. When the track is off the front wheel, remove it from
the drive sprocket and road wheels
7. Beginning at the drive sprocket, coil the new track
around the sprocket, ensuring that the lugs on the track
fit between the spacers on the sprocket
8. Push the track under and between the road wheels
(Figure 7).
9. Starting at the bottom of the front wheel, install the
track around the wheel by rotating the track rearward
while pushing the lugs into the wheel.
10. Using a 1/2 inch drive ratchet, turn the tensioning
screw counter-clockwise until the tensioning screw
bottoms out (Figure
5. Road wheel
6. Pivot tensioner
7. Ratchet (1/2 inch)
(Figure
(Figure 7).
(Figure
8).
g029759
1. Tension nut
11. Align the closest notch in the tension screw to the
locking bolt hole and secure the screw with the locking
bolt and nut
12. Torque the rear bolt to 108 to 122 N∙m (80 to 90 ft-lb).
13. Lower the machine to the ground.
7).
14. Repeat the procedure to replace the other track.
15. Drive the machine, then park the machine on a level
surface, engage the parking brake, shut off the engine,
and remove the key.
Note: The track tension will loosen after some use.
16. Remove the locking bolt and nut
17. Using a 1/2 inch drive ratchet, turn the tensioning
screw counter-clockwise until the tension nut aligns
with the green section of the decal
7).
1. Green section of decal
2. Tension nut
18. Align the closest notch in the tension screw to the
locking-bolt hole and secure the screw with the locking
bolt and nut
19. Repeat steps
4
Figure 8
2. Tension screw
(Figure 6).
(Figure
(Figure
Figure 9
(Figure 6).
16 through 18 for the other track.
g203963
6).
9).
g203962