Rear Terminal Cover Removal; Power Supply Shield Removal; Pwb-Power Removal - Mitsubishi WD-60C9 Service Manual

MODELS: WD-60C9 / WD-65C9 / WD-73C9 / WD-60737 / WD-65737 / WD-73737 / WD-82737
CHASSIS REMOVAL & DISASSEMBLY (Continued)

Rear Terminal Cover Removal

1) Remove nut (A) from the ANT input.
2) Disconnect connector PG2 from the rear of the RS232C assembly (V41+ only).
3) Remove screws (C) and (D).
4) Remove the Terminal Cover from the chassis.

Power Supply Shield Removal

1) Remove screw (A).
2) Remove the Power Supply Shield
from the chassis.

PWB-POWER Removal

1) Remove screws (B).
2) Disconnect all cables from the
PWB-POWER.
3) Lift the PWB-POWER from the
chassis.
PWB-POWER Installation
NOTE: The PWB-POWER should
be re-installed so the Heat Sink is
opposite the Power Supply Shield.
WD-65837 / WD-73837 / WD-82837
PG2
(Rear)
C
D
POWER
SUPPLY
SHIELD
Page 8
(V41+)
RS232C
D
PWB
POWER
B
A
A
HEAT
SINK