Philips HX2565/02 User Manual page 6

ENGLISH
6
C
1
2
C
16 hrs
Instructions for use
Mounting the appliance on the wall
1 Mount the charging unit to the wall.
Do not allow the charging unit to come into
contact with water.The toothbrush, however, is
watertight and can therefore be used safely
anywhere.
To mount the charger to the wall, you will need
2 wood screws (3,5 x 25 mm) and two wall
plugs (S5).They are available in any home centre.
Charging
1 Leave the appliance to charge for at least
16 hours before you use it for the first time.
The toothbrush can be put back in the charging
unit after use.
Only type HX2565: If the battery in the
toothbrush is being charged, the pilot light is green
and blinks. If the battery has been fully charged,
the pilot light burns continuously.
If the battery is almost empty, the pilot light is red
and blinks for 10 seconds after the toothbrush has
been switched off.
Tip:The toothbrush can be left to charge continuously.
When you start using the appliance, we recommend
you to use it until the battery is empty and do so three
times in a row.You can do this by using the appliance in
the normal way without recharging it between brushing
session until the motor almost stops running.To extend