Ordering Parts; Repair Notes - Icom HM-151 Service Manual

INTRODUCTION
This service manual describes the latest service information
for the HM-151 HAND MICROPHONE, at the time of
publication.
MODEL NAME VERSION
[GEN]
[GEN-02]
HM-151
[GEN-01]
[EXP]
To upgrade quality, all electrical or mechanical parts and internal
circuits are subject to change without notice or obligation.

ORDERING PARTS

Be sure to include the following four points when ordering
replacement parts:
1. 10-digit Icom part number
2. Component name and informations
3. Equipment model name and unit name
4. Quantity required
<SAMPLE ORDER>
8810009610 Screw FH M2.6 × 6 ZK
Addresses are provided on the inside back cover for your
convenience.

REPAIR NOTES

1. Make sure the problem is internal before disassembling
the speaker microphone.
2. DO NOT open the speaker microphone until the
transceiver is disconnected from its power source.
3. DO NOT force any of the variable components. Turn
them slowly and smoothly.
4. DO NOT short any circuits or electronic parts. An
insulated tuning tool MUST be used for all adjustments.
5. DO NOT keep power ON for a long time when the
speaker microphone is defective.
Icom, Icom Inc. and the Icom logo are registered trademarks of Icom Incorporated (Japan) in Japan, the United States, the
United Kingdom, Germany, France, Spain, Russia and/or other countries.
HM-151 Top cover 10 pieces