Advertisement
-
Ok
%SP
4.
Wiring diagram
(MOTOR
t)
display (the internal motor should be equipped with the temperature sensor and the
output of temperature detection signa!).
4.
Display 3
CM •
1308.80
ij
88. $35"8.13P
-8888
8'
-OB.
Hold
nl
button shortly in display 2 to enter display 3.
In the riding condition, five seconds later, a single maximum speed (MXS) display automatically
returns to the real riding speed (Km/H).
5.
In display 3, hold
EI
button shortly (SW),and the display will re-enter display 1.
6.
Hold
1231
button to turn off the display and the power supply of controller.
7.
Automatically prompt interface
7.1
Error Code display
Error Code
Definition
01
info
Throttle Abnormality
03
info
Motor hall signal Abnormality
e a
,HR6
04 info
Torque sensor signal Abnormality
05
info
Axis speed sensor Abnormality(only applied to torque
sensur)
06_info
Motor or controller has short circuit Abnormality
Electronic control system failure will display (flashing) fault code. Once the fault was removed, it
automatically exits from the fault code display interface.
7.2
Motor temperature alarm
When the motor temperature (the internal motor should be equipped with the temperature
sensor and the output of temperature detection signal) is over the warning value, MOTOR "C (1F)
flashes to alarm at any display, meanwhile the motor controller will offer the appropriate protection to
motor.
After power on for 5 seconds, hold
a
and El button at the
2 '-i.
same time, maximum riding speed Km/H and MXS flash, hold
n
or
1
2
button shortly to set the maximum riding speed (default 25Km/H).
Hold
In
button shortly and go to the next parameter settings.
2.
Wheel diameter setting
The wheel diameter will be set after finishing setting the maximum
riding speed, wheel diameter specifications flashes. Hold
or
button shortly to set the specifications of wheel diameter. Select the
range 6,8,10,12,14,16,18,20,22,24,26,700c and 28 inches. Hold
button shortly and go to the next parameter settings.
3. Set the metric units
{Mg
The metric units will be set after finishing setting wheel diameter,
p
88.-U 81
'P
8888
W-188::
Km/H and Km flash. Hold in or
1:3
button shortly and select the
three metric units of speed, mileage, and ambient temperature in
synchronization.
Display
Metric
Imperial
Riding speed
Km/1-1
MPH
Total distance
Km
Mil
Environment temperature
"C' Temperature
"I' Fahrenheit
4.
Km/H and Km stop flash after metric unit setting is completed. Hold Eall button shortly again to
re-enter the maximum riding speed setting interface; or hold
button long to exit from setting
environment of routine projects and save the setting ialues, returning to display 1.
5.
Exit from routine project setting
All three routine project settings cao exit from the setting environment and return to the display
if hold
button long after each setting is completed, meanwhile the setting values are saved.
Under each setting in..erface, if the button failed holding for more than 1 minute, it will
automatically return to display 1, and the setting value is invalid.
Oudine Drawings and Dimensions
1.
Dimensions of main instrument body
2. Mounting dimensions of double brackets
20
14
is optional 4, 22. 2 or 4, 25. 4
11177111
58
Ni
3.
Dimensions of button box
1
h
)
W1 ' 1 '
General Project Setting
1.
Set maximum riding spend
<__.~',.• '888 Ra
'¢q
BB.
g•es
,
*8888
B' <BB
the encired rubber fielded panel 1
86
Advertisement
