eBike KT-LCD8H User Manual

KT-LCD8H eBike Display User Manual
Dear customer, please read this manual before you use KT-LCD8HDisplay. The manual will guide you use
the instrument correctly to achieve a variety of vehicle control and vehicle status displays.
Functions and Display
Instruments using the structure form of instrument body portion and the operation buttons are
designed separately.
1 UP Button
2 SW Button
3
DOWN Button
4 MOTOR
Power display
W
ASSIST
Pas level
5
6Km/H push power assist
6 THROTT Run sign
LE
7
Battery capacity indicator
8 VO
Battery voltage
L
9
The brake display
1. Operation
1. ON/OFF
Hold button long to turn on the power, and hold
the power. When the motor stops driving and when the e-bike is not used for a consecutive
5 minutes, it will automatically shut down and turn off the motor power supply.
2. Display 1
Hold
2.1 Turn on backlight and headlights
Hold
controller should have headlight drive output function); hold
10 Backlight and headlights
℃ Environment temperature
11
℉
Environment fahrenheit
12 Km/H
Riding speed(metric)
AVS
Average speed
13
MXS MAX speed
DST Trip distance
14
ODO
Total distance
TIM
Single trip time
15
TTM
Total trip time
long for a second time to turn off
button to start up and enter display .
long to turn on backlight and headlights (the
long again to turn off the backlight and headlights.
2.2 Assist ratio gear (ASSIST) switch
Hold
the minimum power, gear 5 is for the highest power. Each startup
will automatically restore the gear shutdown last time (the user can
set randomly). Gear 0 is without booster function.
2.3 6Km/H assist promotion function
Hold
more than 6Km /h. Release
2.4 Display and delete of single data
After power on for 5 seconds, hold
same time, single trip riding time (TM) and single trip distance
(DST) flash, hold
cleared. If failed holding the button within 5 seconds, it will
automatically return the display interface after 5 seconds, original content is preserved.
3.Display 2
Hold
In the riding mode after 5 seconds, display 2 automatically
returns to display 1, and the original motor power (MOTOR W)
display is replaced with motor operating temperature display
(MOTOR ℃) display (the internal motor should be equipped
with the temperature sensor and the output of temperature detection signal).
4.Display 3
Hold
In the riding condition, five seconds later, a single maximum
speed (MXS) display automatically returns to the real riding
speed (Km/H).
5. In display 3, hold button shortly (SW),and the display will re-enter display 1.
6. Hold button to turn off the display and the power supply of controller.
or shortly to switch 1-5 file gear. Gear 1 is for
and flashes, the vehicle drives at the speed not
button, the function is invalid.
and at the
button shortly, the content of both is
button shortly in display 1 to enter display 2.
button shortly in display 2 to enter display 3.