Philips HQ564/16 Instructions For Use

Opening for shaving emulsion
ENGLISH
Cool Skin shaving heads
HQ 564/563
Release button shaving unit
Philishave
Pump button
Cool Skin
Cartridge compartment cover
Pilot light
Instructions for use
ON/OFF button
Release button of cartridge
compartment
Introduction
Cool Skin is a new shaving system by Philishave. The shaver
has a special compartment for cartridges containing Nivea
for Men moisturising shaving emulsion. This emulsion is
applied to the skin during shaving. The Nivea for Men
shaving emulsion prepares the skin and beard for the shave,
ensuring that the shaver moves smoothly over your face and
makes perfect contact with the skin. You will enjoy an
unexpectedly close and comfortable shave and your skin will
feel soft and fresh afterwards.
After shaving, you can clean the appliance by simply rinsing
it under a hot tap.
Important
Allow your skin at least two weeks to become
accustomed to the Philishave shaving system.
Do not press the shaver too hard against the
skin while shaving!
With this shaving system, you can shave when
your skin is either wet or dry. The Nivea for
Men shaving emulsion has an immediately
moisturising effect on the skin.
Remove the cartridge and clean the shaver if
you are not going to use the appliance for more
than one week.
To obtain the best shaving results, it is
necessary to follow the instructions in the
'Cleaning and maintenance' section.
Charging the shaver
Important: only leave the shaver to charge in a dry place!
First put the plug in the appliance and then put the
Powerplug in the socket. The Powerplug has an
automatic voltage selector and is suitable for mains
voltages ranging from 100 to 240 Volts. The pilot light
near the ON/OFF button will go on. It will take the
appliance approximately 8 hours to recharge
completely. A fully recharged shaver has a shaving time
of approximately 30 minutes. The shaver has been
equipped with a 'battery low' indication: the pilot light
will light up when the battery is running low.
About the built-in battery
The shaver has been equipped with a built-in
rechargeable battery. To prolong the life of the battery,
recharge and store the appliance at a temperature
between +5°C and +35°C. Also make sure that you
disconnect the shaver from the mains when you are
not recharging it.
Inserting the cartridge
The cartridges with moisturising Nivea for Men shaving
emulsion are available in boxes containing five
cartridges and one plastic connector. Do not throw the
connector away; you will need it for all five cartridges!
Use only Philishave Nivea for Men Cool Skin
cartridges (HQ 150).
Inserting the first cartridge
Take one cartridge from the box. Take the connector
(supplied in the same box) out of its bag and push it
into the cartridge until it seats with a click.
Push the release slide downwards and remove the
2
cover from the cartridge compartment.
Slide the cartridge with inserted connector into the
shaver. Replace the cover and close it.
1
Replacing an empty cartridge
Push the release slide downwards and remove the
cover from the cartridge compartment. Remove the
empty cartridge and pull out the connector.
Note: do not throw the connector away!
Insert the connector into a new cartridge. It has
been properly inserted when it seats with a click.
Slide the new cartridge with the connector into the
shaver. Replace the cover and close it.
About the cartridge
The Nivea for Men shaving emulsion in this cartridge
will keep when it is stored at a temperature between
0°C and +40°C.
Shaving
Switch on the shaver by pressing the ON/OFF button.
Hold the shaver against the skin.
Press the yellow pump button to apply Nivea for
Men shaving emulsion to the skin. When sufficient
shaving emulsion has been released, start moving the
shaving heads rapidly over your skin, making both
straight and circular movements.
The shaver is suitable for use in the shower.
Grooming sideburns and moustaches
Trimmer
The shaver has a separate trimmer for grooming
sideburns and moustaches.
Fitting the trimmer onto the shaver
Switch off the shaver.
Clean the shaver before you assemble the trimmer.
Press the release button and pull the shaving unit off
the shaver.
Fit the trimmer onto the shaver.
Removing the trimmer
Press the release button and remove the trimmer.
4222 001 83073