Connecting Picture Of The Measuring Instrument; Auto-Control Interface And Directions; Auto Adjustment Map(Rs-232C) - LG 32LN540B-CN Service Manual

LG Electronics Inc. Display Division
Establish : 12/09/15
Reform : 12/09/15
Connecting picture of the measuring instrument (On Automatic control)
Inside PATTERN is used when W/B is controlled. Connect to auto controller or push Adjustment R/C P-ONLY à
Enter the mode of White-Balance, the pattern will come out.

Auto-control interface and directions

1. Adjust in the place where the influx of light like floodlight around is blocked. (Illumination is less than 10ux).
2. Adhere closely the Color Analyzer ( CA210 ) to the module less than 10cm distance, keep it with the surface of
the Module and Color Analyzer s Prove vertically.(80~100°).
3. Aging time
-. After aging start, keep the power on (no suspension of power supply) and heat-run over 5 minutes.
-. Using no signal or POWER ONLY or the others, check the back light on.

Auto adjustment Map(RS-232C)

RS-232C COMMAND
[ CMD ID
Wb 00
Wb 00
R Gain
G Gain
B Gain
R Cut
G Cut
B Cut
* Manual W/B process
LC36B Adjust specification
DATA ]
00 White Balance Start
ff White Balance End
RS-232C COMMAND
[CMD ID DATA]
Cool Mid Warm
jg Ja jd
jh Jb je
ji Jc jf
using adjusts Remote control.
CENTER
(DEFAULT)
MIN
Cool Mid
00 172 192
00 172 192
00 192 192
64 64
64 64
64 64
LG(55)C2-0661-00
MAX
Warm
192 192
192 192
172 192
64 128
64 128
64 128
L G e l e c t r o n i c s
11/25