IKEA FROSTIG Manual page 17

ENGLISH
Problem
The compressor does not
start immediately after
pressing Shopping, or after
the change of the tempera-
ture.
Water flows inside the re-
frigerator.
Water flows on the floor.
Temperature cannot be set.
DEMO appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
Possible cause
This is normal, no error has
occurred.
Food products prevent
water from flowing into the
water collector.
The melting water outlet is
not connected to the evap-
orative tray above the
compressor.
The Shopping is switched
on.
The appliance is in demon-
stration mode.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products temper-
ature is too high.
Many food products were
inserted at the same time.
The door has been
opened too often.
The Shopping is switched
on.
Solution
The compressor starts after
some time.
Make sure that food products
do not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Switch off Shopping manually,
or wait until the function resets
automatically to set the tem-
perature. Refer to " Shop-
ping".
Keep the OK pressed for ap-
proximately 10 seconds until a
long sound is heard and dis-
play shuts off for a short time.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Insert less food products at the
same time.
Open the door only if necessa-
ry.
Refer to "Shopping".
17