Service & Repair; Warranty Conditions - Level Pro 300 Series Installation Manual

Levelpro-Sensors Manual
Heavy Duty Industrial Level Transmitter
6. SERVICE | REPAIR
6.1 Return
Before every return of your device, whether for recalibration, decalcification, modifications or repair, it
has to be cleaned carefully. You have to enclose a notice of return with detailed defect description
when sending the device. If your device came in contact with harmful substances, a declaration of
decontamination is additionally required. Appropriate forms can be downloaded from our homepage
(http://www.iconprocon.com). Should you dispatch a device without a declaration of
decontamination and if there are any doubts in our service department regarding the used medium,
repair will not be started until an acceptable declaration is sent.
If the device came in contact with hazardous substances, certain precautions have to be
complied with for purification!
7. DISPOSAL
The device must be disposed according to the European Directives 2002/96/EG and
2003/108/EG (on waste electrical and electronic equipment) Waste of electrical and
electronic equipment may not be disposed by domestic refuse!
WARNING! Depending on the measuring medium, deposit on the device may cause danger
for the user and the environment. Comply with adequate precau-tions for purification and
dispose of it properly.

8. WARRANTY CONDITIONS

The warranty conditions are subject to the legal warranty period of 12 months from the date of
delivery. In case of improper use, modifications of or damages to the device, we do not accept
warranty claims. Damaged diaphragms will also not be accepted. Furthermore, defects due to normal
wear are not subject to warranty services.
TECHNOLOGY
The Levelpro pressure transmitter is placed near or on the bottom of the tank. A ceramic pressure
diaphragm within the pressure transmitter is exposed on one side to the application liquid. The other
side is exposed to the reference pressure via a small ventilation tube located inside of the cable. The
difference in pressure between liquid and reference pressures will slightly deflect the diaphragm.
The deflection of the diaphragm is measure by a built-in microprocessor located inside the ceramic
diaphragm.which is converted into a 4-20mA two wire current signal proportional the height of the
liquid.
Make sure that Levelpro Transmitter is compatible with the application liquid media.
7