Philips CEM220/98 User Manual page 12

Mount in the dashboard
1
If the car does not have an on-board drive
or navigation computer, disconnect the
negative terminal of the car battery.
• If you disconnect the car battery in
a car that has an on-board drive or
navigation computer, the computer
may lose its memory.
• If the car battery is not disconnected,
to avoid short-circuit, ensure that bare
wires do not touch each other.
2
Remove the two screws on the top of the
unit.
3
Remove the mounting sleeve with the
supplied disassembly tools.
4
Ensure that car dashboard opening is
within these measurements:
5
Install the sleeve into the dashboard and
bend the tabs outward to fi x the sleeve.
Note
•
Skip this step if the unit is not fi xed by sleeve but by
supplied screws.
EN 13