brennenstuhl PM 231 Operating Instructions Manual page 30

Operating instructions PM 231 E
GB
You can move the decimal point by pressing the SET
button (5) to start flashing and move it with the UP button (4)
to the correct position.
Press the SET button (5) again, and the time display
(- : - -) behind ON TIME (24) for the entered price 1
(18) starts flashing. Press SET (5) to finish the setting
procedure for price 1 if no second price is needed.
To enter a second price (e.g. day/night tariff) also set a
starting point for price 1 first. While the time display is
flashing behind ON TIME (24) for price 1 (18) press UP
button (4) to set the day of the week for the starting point
(see previous section). Now press the SET button (5) until
the hour display starts flashing and press the UP button (4)
to set the hours for the starting point. Repeat this proce-
dure for the minute display. Finally press the SET button (5)
to finish price 1 settings.
Set Cost/kWh (Price 2)
Setting the cost/kWh for price 2 is similar to price 1.
Ensure that at the beginning price 2 (18) is displayed.
Press the FUNC button (6) to toggle the display to show
price 2 (18) before starting the setting procedure with the
SET button (5).
30
21518 BA_PM 231 DE 0454552.indd 30 05.04.18 14:41