Philips CED370/00 User Manual page 12

Connect wires: without ISO
connectors
Caution
•
Ensure that all loose leads are insulated with
electrical tape.
1
Cut off the bigger end of the supplied
standard connector.
2
Check the car's wiring carefully, then
connect them to the standard connector.
9
8
7
6
Connector
1 Yellow wire
2 Blue wire
3 Orange wire Illumination switch
4 Black wire
5 Red wire
1
2
6 Green and
3
green/black
wires
4
7 White and
5
white/black
wires
8 Gray and
gray/black
wires
9 Purple and
purple/black
wires
Connect to
The +12V car battery
which is live at all times.
The electric antenna
control lead or power
supply lead of the
antenna booster
If there is no electric
antenna or antenna
booster, or it is manually
operated telescopic
antenna, it is not necessary
to connect this lead.
A metal surface of the
car
First connect the black
ground (earth) lead, then
connect the yellow and
red power supply leads.
The +12V power terminal
which is live in the
accessory (ACC) position
of the ignition switch
If there is no accessory
position, connect to the
+12V car battery terminal
that is always live. Be
sure to connect the black
ground (earth) lead to a
metal surface of the car
first.
Left speaker (Rear)
Left speaker (Front)
Right speaker (Front)
Right speaker (Rear)
EN 13