Operation - Tesco JKBP14G User Manual

ABOUT YOUR KETTLE
KEY
1. Spout
2. Water Filter (In Spout)
3. Kettle Lid
4. Lid Release
5. Handle
6. Illuminated ON/OFF Switch
7. Kettle Base
8. Kettle Jug
9. Water Scale
PRELIMINARIES
Unpack your kettle and any accessories carefully. Retain the
packaging so that you can transport the appliance safely. If
you dispose of it please do so with regard to any recycling
regulations in your area.
Before using your kettle:
Check that the voltage marked on the rating plate under the
kettle or the base matches your mains voltage. Please read all
the instructions in this User Guide with particular reference to
the safety notes.

OPERATION

Separate the kettle from the base.
Ensure that the mains socket is switched off at the wall. Lead
the power cord out through the recess in the base. Place the
kettle base on a stable level surface and connect the power cord
to the wall socket. Excess cord may be safely stowed by feeding
it carefully into the stowage compartment in the base. Ensure
the power cable exits through the cut out slot otherwise the
kettle base will not be stable.
Pour away previously boiled water
Press the lid release button to lift up the lid.
Fill the kettle with fresh water. The MIN and MAX marks are
located on the water scale . The water level must always cover
the MIN (0.5 litres) mark . Do NOT fill the kettle above the MAX
mark (1.7 litres) , or boiling water may be ejected. Close the lid
b
c
7
j
i
Place the filled kettle correctly on the power base.
Boiling the Kettle:
Switch on the power at the wall socket.
The kettle ON/OFF switch is located below the handle. Press this
down to the "I" position to switch the kettle on. The switch will
illuminate showing the kettle is operational.
When the water has reached the correct temperature, the kettle
will switch off.
You can stop the boiling at any time by lifting the switch up to
the "0" position. To re-boil, press the switch again. If the water is
very hot, it may be necessary to wait until the switch resets.
Always ensure the lid is tightly fitted and never lift it while the
kettle is boiling or you run the risk of scalding. If the lid is not
correctly fitted while boiling, the automatic cut-out will not
operate, you may boil the kettle dry and cause damage due to
excessive steam emissions.
After boiling, switch off the appliance at the mains.
The kettle may now be safely removed from its base and the
boiled water poured out. Always take care to pour boiling water
slowly and carefully without tipping the kettle too quickly.
Never leave hot water in the kettle while it is unattended.
After use, replace the kettle on its base.
THIS APPLIANCE MUST BE ATTENDED AT ALL TIMES WHEN
OPERATIONAL.
EN
3
JKBP14G/ R/ S
d
e
f
g
h