Tesco JK07 User Manual

DESCRIPTION
IMPORTANT NOTICE TO UK USERS
The appliance cord is terminated with a UK approved mains plug fitted
with a 13A fuse. If the fuse needs to be replaced, an ASTA or BSI
approved BS1362 fuse rated at 13A must be used. If you need to change
the mains plug, remove the fuse and dispose of this plug safely
immediately after cutting it from the cord.
Connecting a Mains Plug
The wires in the mains lead are coloured in accordance with the code:
Blue: NEUTRAL Brown: LIVE Green & Yellow: EARTH.
As these colours may not correspond to the coloured markings identifying
the terminals in your plug, proceed as follows:
The wire coloured BLUE
must be connected to the
13A
terminal marked with the
BS 1362
letter N or coloured BLUE
or BLACK. The wire
coloured BROWN must
be connected to the
terminal marked with the letter L or coloured BROWN or RED. The wire
coloured GREEN & YELLOW must be connected to the terminal marked
with the letter E or coloured GREEN or GREEN & YELLOW or marked with
the Earth Symbol
PRELIMINARIES
Lid
Unpack your kettle and any accessories carefully. Retain the packaging
Lid Release
so that you can transport the appliance safely. If you dispose of it please
Spout
do so with regard to any recycling regulations in your area.
ON/OFF Switch
Before using your kettle:
Water Filter*
Check that the voltage marked on the rating plate under the kettle or the
*Inside Kettle Jug
base matches your mains voltage.
Kettle Jug
Please read all the instructions in this User Guide with particular
reference to the safety notes.
Water Gauge
Handle Before first use or after storage:
Fill the kettle with fresh water, boil it and then pour away the boiled
Element*
water. Repeat this two or three times. The kettle is now ready for use.
*Inside Kettle Jug
CONNECTING AND USING THE KETTLE
Kettle Base
IMPORTANT: THIS APPLIANCE MUST BE EARTHED
Separate the kettle from the base.
Ensure that the mains socket is switched off at the wall. Lead the power
cord out through the recess in the base. Place the kettle base on a stable
level surface and connect the power cord to the wall socket. Excess cord
may be safely stowed by feeding it carefully into the stowage
compartment in the base.
Press the lid release back and then open the lid.
Pour away previously boiled water and use fresh water to fill the kettle.
Fill the kettle carefully. The water level must always cover the lowest
mark on the gauge. Do NOT fill the kettle above the MAX
litres) or boiling water may be ejected. If you cannot see the water level
through the scale, the level is incorrect.
Press the ON/OFF switch down (O position).
Position the filled kettle correctly on the power base.
Switch on the power at the wall socket. Press the
ON/OFF switch up (I position). The switch will
illuminate showing the kettle is operational.
When the water has boiled, the kettle will switch off automatically. You
can stop the boiling at any time by pressing the switch down.
To re-boil, depress the switch again. If the water is very hot, it may be
necessary to wait a few seconds before the switch can be reset.
Always ensure the lid is closed and never lift it while the kettle is boiling
or you run the risk of scalding. If the lid is left open while boiling, the
automatic cut-out will not operate and you may boil the kettle dry.After
boiling, switch off the appliance at the mains.
The kettle may now be safely removed from its base and the boiled water
poured out. Always take care to pour boiling water slowly and carefully
without tipping the kettle too quickly.
After use, replace the kettle on its base.
SAFETY AND OTHER FEATURES
Boil Switch with Auto Cut-Out
When the switch is depressed, the switch illuminates to shows that the
kettle is operational. After boiling, the kettle is automatically switched
off and the illumination extinguished.
Note: When boiling water, do NOT hold the switch up or steam will be
ejected from the lid and you may damage the automatic switch off
mechanism. Always ensure that the ON/OFF switch is clear of
obstructions, readily operable and is not prevented from switching off.
Boil Dry Protection
Your TESCO kettle is fitted with a safety device which switches it off if the
appliance is operated with insufficient water. If this occurs, the kettle
should be switched off at the mains and allowed to cool thoroughly
before refilling with cold water. The safety device will then reset.
Overheating Shut -Off
In the event of gross overheating, your TESCO kettle will automatically
shut down to prevent further damage. Should this occur, take it to a
mark (1.7
8
qualified service person for examination and repair.
Removable Scale Filter
The mesh filter in the kettle spout traps scale. If you fill the kettle via the
spout, the effectiveness of this filter will be reduced.
ON
OFF
To remove the filter, allow the kettle to
cool, open the lid, hold the filter as
shown and lift it out.
Brush the filter in running water to
remove any adhered scale.
To replace, align the filter in the slot in
the spout and press into place.