Philips CED1700/51 User Manual page 10

Connector Connect to
1 Yellow wire The +12V car battery
which is live at all times.
2 Blue wire The electric antenna
control lead or power
supply lead of the
antenna booster
If there is no electric
antenna or antenna
booster, or it is manually
operated telescopic
antenna, it is not necessary
to connect this lead.
3 Black wire A metal surface of the car
First connect the black
ground (earth) lead, then
connect the yellow and
red power supply leads.
4 Red wire The +12V power terminal
which is live in the
accessory (ACC) position
of the ignition switch
If there is no accessory
position, connect to the
+12V car battery terminal
that is always live. Be
sure to connect the black
ground (earth) lead to a
metal surface of the car
ÀUVW
5 Green and Left speaker (Rear)
green/black
wires
6 White and Left speaker (Front)
white/black
wires
7 Gray and Right speaker (Front)
gray/black
wires
8 Purple and Right speaker (Rear)
purple/black
wires
2
Connect the other end of the supplied
standard connector to the car audio
system.
Caution
‡ In order to avoid any accident, the driver must
not watch video while driving. This unit is
designed to not allow watching moving video
while driving. Park your car in a safe place and
engage the parking brake before watching
moving video.
Note
‡
The video blocking system under parking
brake not engaged only control this unit's
display, and will not affect the video output
through the rear RCA video output.
‡
If watch moving video from Disc or AV-In
source but parking brake is not properly
connected, the video signal will be blocked
by the system, and the below display will be
shown on TFT:
EN 11