Please use this QR Code to access more documents and Video Tutorials related to the product. Thank you for your purchase of LinkPro Z. This is a Zigbee Mesh Controller which operates at 2.4GHz. Minimize or eliminate any sources of RF interference and shielding.
Screws (PH2) Ring Screws (PH2) (1) 2 Meter CAT5e (2) Drywall (1) 48v Passive PoE Anchors (1) 48v Passive PoE Injector - Brick Injector - Wall Wart LinkPro Z - Parts in the Box LinkPro Z - Parts in the Box...
Page 4
3/4" hole for NOTE: Original Mounting Ring installation process is CAT5e/6 similar to Magnetic Mount. For more details contact support. 2. Mark the mounting hole locations (these holes are (cont. to next page) LinkPro Z - Installation LinkPro Z - Installation...
Page 5
4. Gently drive the drywall anchors into the 7/32" holes. 6. Plug in the LinkPro Z and align the magnets on the Locate your CAT5e/6 cable and pass it through the back of the device with two of the recessed areas hole drilled.
Page 6
7. There should be an audible click. (cont. to next page) LinkPro Z - Installation LinkPro Z - Installation...
Page 7
8. Now connect the other end of your CAT5e/6 to a PoE switch (sold seperately)/ PoE injector (incl.) Plug it into PoE/ Power Output Note: A valid LAN connection is highly recommended to connect to the LAN port of these injectors, otherwise LinkPro Z will use WIFI. LinkPro Z - Installation...
Page 8
9. Press “Create Group” and repeat steps 6 - 8 for all of 2. Power your LinkPro Z using a PoE switch or the the shades in the room. provided PoE injector, and wait until the LED on the 10.
www.screeninnovations.com/accessories/linkpro Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver FCC INFORMATION Connect the equipment into an outlet on a circuit different This device complies with Part 15 of the FCC Results. from that to which receiver is connected. Consult the dealer Operation is subject to the following two conditions: or experienced radio technician for help.