TPI 383a Manual

Combo non-contact/contact thermometer

Combo non-contact /

contact thermometer 383a

Use standard K-type thermocouple probes with

sub mini input jack. Probes purchased separately

Test the TPI Advantage

TestProducts International, Inc.

• Contact and non-contact thermometer

• Maintain reading on display

• Laser sighting

• Backlit display

• 9:1 distance to spot ratio

• 0.1 degree resolution

• 095 emissivity

• 3 Year Limited Warranty

Visit www.testproductsintl.com

Table of Contents

Need help?

Do you have a question about the 383a and is the answer not in the manual?

Page 1 Combo non-contact / contact thermometer 383a TestProducts International, Inc. • Contact and non-contact thermometer • Maintain reading on display • Laser sighting • Backlit display • 9:1 distance to spot ratio • 0.1 degree resolution • 095 emissivity • 3 Year Limited Warranty Use standard K-type thermocouple probes with sub mini input jack.
Page 2 A. INTRODUCTION 1. Congratulations: Thank you for purchasing TPI products. The 383a is easy to use and built to last. It is backed by a 3 year limited warranty. 2. Product Description: The 383 is a non-contact and contact temperature tester with laser sighting to confirm you target.
Page 3 D. MEASUREMENT TECHNIQUES Push Buttons TRIGGER: Press and hold the trigger button on the 381a. The thermometer will power up and the laser will be visible (unless in contact “K” mode). After releasing the trigger, the thermometer will hold the last reading then automati- cally turn off after 10 seconds.
Page 4 • Target surface has poor emissivity qualities. • Laser sight out of alignment. 383a does not turn on. • Dead or low battery. • Defective POWER ON switch. • Broken batter connector. Laser does not turn on.