Troubleshooting - WeatherTech Truck Bed Cover Installation Instructions And Owner's Manual

Table of Contents

Advertisement

TROUBLESHOOTING

PROBLEM
Cover too loose
Cover too tight
Gap between rear bar and tailgate
Top of tailgate hits rear bar when attempting to
close
Cover too narrow
Cover too wide
Lopsided cover (too much on one side)
Dual locking system doesn't engage
SOLUTION
Turn both tension adjusters counter clockwise
to move front bar forward (see Step 6D).
Turn both tension adjusters clockwise to
move front bar back (see Step 6D).
Side rails set too high (see Step 6B).
Raise side rails at rear of box until tailgate
closes without pushing rear bar up (see Step
6B).
Check if side rail is level. If side rail tilts up:
loosen and lower clamp, engage teeth and
then retighten clamp (see Step 1H).
Check if side rail is level. If side rail tilts down:
loosen and raise clamp, engage teeth and
then retighten clamp (see Step 1H).
Check if front bar is centered between side
rails (see Step 5E).
Check side rails for height and level (see
Step 1K). Inspect latches for jammed or
broken parts.
12

Advertisement

Table of Contents
loading

Table of Contents