Contents Lojer 3-section bench ............................3 Sections of the 3-section bench ......................... 3 Lojer 3-section bench ............................3 Accessories ................................ 4 Symbols used on the Pulleys ..........................4 Delivery inspection ............................4 Before use ................................. 4 Installation ................................. 5 Warnings ................................6 Functions and adjustments..........................
This document will provide you with the instructions you need to operate and maintain the Lojer 3-section bench. Carefully familiarise yourself with this manual before unpacking and using the device. Use the device only as described and for the specified applications.
Accessories Accessories available for Lojer 3-section bench are seen in the Figure 2 which enable different type of exercises. Use only accessories that are defined by the manufacturer. Figure 2: Accessories a) 161001 Neck support b) KT8163 Shoulder rotation Symbols used on the Pulleys The following symbols and markings are used on all Lojer Pulleys.
Installation For the installation you need following tools (Figure 3): Figure 3: Allen keys 5mm and 6 mm; Box spanner 13 mm The package should include all parts seen below (Figure 4). Figure 4: Parts included in the package Place parts 2 and 3 on according to the figure below (Figure 5). Figure 5: Installation of parts 2 and 3 Attach the parts to the bench with a bolt and nut.
Place parts 4 and 5 according to the figure below (Figure 6). Figure 6: Installation of parts 4 and 5 Attach part 4 to the end of the bench which has the adjustable seat. Attach the parts to the bench with a bolt and nut. Make sure that all bolts are properly tightened.
Neck support (accessory) A neck support is available as an accessory for Lojer 3-section bench. It support the patient’s head and neck during exercise. Keep the neck support on the side of the bench (the pad outward) when the support is not used.
Shoulder rotation trainer (accessory) Shoulder rotation trainer is to be installed to that end of the Lojer 3-section bench where you can find the castors. Install the device as seen in the Figure 9. Figure 9: Shoulder rotation trainer Figure 9: Shoulder rotation trainer...
Figure 10: Type plate and its location Standards LOJER 19100 Pulley, 19200 Speed Pulley and 19300 Vertical Pull are in conformity with the following essential requirements of the Directive 93/42/EEC (Medical Devices) and the corresponding Finnish National Law no. 629 (2010).
The defective parts removed from a product as part of a warranty case shall become the property of LOJER and shall be retained for by the End Customer for LOJER, if necessary. If these parts cannot be returned to LOJER upon request, LOJER is entitled to charge for a corresponding amount.
Page 11
LOJER factory in Finland. For this, the customer is responsible for the despatch and insurance of the product. The transport and insurance costs shall be borne by the customer. LOJER shall assume the costs for the materials / spare parts and the labour costs as required, as well as the standard return transportation to the sender.