Advertisement
Radio Play
You can tune to any FM station automatically or
manually.
1 Press FM to switch the radio on.
Tuning to radio stations automatically
1 Keep ∞ or § pressed for at least 2 second.
yThe radio tunes to a station with sufficient
strength and radio play starts. The current
waveband and frequency are displayed.
2 Repeat searching until you find the desired radio
station.
Tuning to radio stations manually
1 Keep ∞ or § pressed.
2 Release ∞ or §, then briefly press ∞ or § again
when you are close to the desired frequency.
3 Briefly press ∞ or § repeatedly until you reach the
desired frequency.
yRadio play starts. The current waveband and
frequency are displayed.
• To switch from radio play to CD play, press 2; .
• Press FM or 9 to switch the radio off.
Antennas
The headphone wire is used as an FM antenna.
If necessary, move it for optimum reception.
Storing radio stations
You can store up to 30 radio stations (1-30).
1 Tune to a desired radio station and press PROG.
2 Press PRESET3 ,4 repeatedly if necessary to select
the number that should be assigned to this radio
station.
3 Press PROG while
is blinking to
PRESET
confirm the storage.
y
, the waveband, the frequency and the
PRESET
preset number of the stored station are
displayed.
4 Store all desired stations this way.
Note: Already stored stations can be recognized by the
indicator
and the preset number.
PRESET
Tuning to a stored radio station
1 Press FM to switch the radio on.
2 Press PRESET3 ,4 once or more to find your preset station.
yRadio play starts. program, the waveband, the frequency and the
preset number of the stored station are displayed.
FEATURES
TROUBLESHOOTING
Troubleshooting
WARNING: Under no circumstances should you try to repair the set yourself as
this will invalidate the guarantee. If a fault occurs, first check the points listed,
before taking the unit for repair. If you are unable to solve a problem by following
these hints, consult your dealer or service centre.
The CD player has no power, or playback does not start
• Check that your batteries are not dead or empty, that they are inserted
correctly, that the contact pins are clean.
• Your adapter connection may be loose. Connect it securely.
• For in-car use, check that the car ignition is on. Also check player's batteries.
The indication no diSC is displayed
• Check that the CD is clean and correctly inserted (label-side upward).
• If your lens has steamed up, wait a few minutes for this to clear.
The indication nF diSC is displayed
• CD-RW (CD-R) was not recorded properly. Use FINALIZE on your CD-recorder.
The indication
is on and/or there is no reaction to controls
HOLD
• If HOLD is activated, then deactivate it.
• Electrostatic discharge. Disconnect power or remove batteries for a few seconds.
The CD skips tracks
• The CD is damaged or dirty. Replace or clean the CD.
• RESUME, SHUFFLE or PROGRAM is active. Switch off whichever is on.
Troubleshooting
No sound or bad sound quality.
• PAUSE might be active. Press 2;.
• Loose, wrong or dirty connections. Check and clean connections.
• Volume might not be appropriately adjusted. Adjust the volume.
• Strong magnetic fields. Check player's position and connections. Also keep
away from active mobile phones.
• For in-car use, check that the cassette adapter is inserted correctly, that the car
cassette player's playback direction is correct (press autoreverse to change),
and that the cigarette lighter socket is clean. Allow time for temperature
change.
CAUTION
Use of controls or adjustments or performance of procedures other than
herein may result in hazardous radiation exposure or other unsafe
operation.
Advertisement
