Step 11: Connect The Wiring - EdgeStar BIDW1802SS Installation Manual

Step 11: Connect the Wiring

1. Before connecting the power cable to the dishwasher, make sure the circuit breaker is off.
2. In the junction box located at the front right bottom of the dishwasher, located the three power
wires for the dishwasher including the ground wire.
3. Pass the power cable through the strain relief connector and into the junction box.
4. Connect the black wire of the dishwasher to the black wire of the power cable using a wire nut.
5. Connect the two white wires and the two green wires in the same manner.
6. Recheck each set of wires to ensure they a connected correctly and securely.
7. Replace the junction box cover
Warning: Electrical Shock Hazard
 To avoid electrical shock, do not work on an energized circuit. Doing so could result in
serious injury or death. Do not attempt to work on the dishwasher until the circuit breaker
has been turned off.
 Only a qualified electrician should perform electrical work.
 To avoid a fire hazard, make sure electrical connections are properly installed by a qualified
electrician.
14