Step 8: Place The Dishwasher And Connect The Water Supply Line - EdgeStar BIDW1802SS Installation Manual

2. Use the level to check whether the dishwasher is level front to back by placing the level
against an inside vertical surface of the tub. If the dishwasher is not level, adjust the height of
the rear legs until the dishwasher is level.
3. Open the door of the dishwasher and check if both the tub and door clearances from the
counter top are correct. If not, adjust the leveling legs to assure the proper clearances. Make
sure the dishwasher remains level after any clearance adjustments are made.

Step 8: Place the Dishwasher and Connect the Water Supply Line

1. Ensure the dishwasher is level and has the proper clearance per the steps in the previous
section
2. Locate the water supply line and the power cable.
3. Place the dishwasher so that the power cable is in the right base channel. Use standard duct
tape or cable ties to secure the cable in the channel. This will prevent the electrical cable from
being twisted or coming out of the channel when the dishwasher is slid into place.
4. Pull the drain hose through the hole in the sink cabinet side wall. Keep it free of kinks. Use a
rubber connector and hose clamps to connect an additional drain hose if the one provided is
not long enough.
9