Advertisement
Using the WiFi-201 in USB mode:
USB mode allows you to use your WiFi module as if it were a
NeuLog USB-200. This requires a computer which has the NeuLog
software (available as a free download on www.NeuLog.com).
By connecting the WiFi module to your sensors and computer via the
included USB to micro USB cable, you are able to stream data
directly from your sensors to the NeuLog browser based application.
To enter USB Mode:
1.
Download and install the NeuLog browser based application
onto the computer which you plan on using.
The
application
can
www.NeuLog.com
as well as a full application user guide.
Choose "Downloads" on the main menu and then choose
"Software and Application".
2.
Connect the WiFi module to the computer with the NeuLog
application using the included USB to micro USB cable, you‟ll
see the LED lights blink for a moment while the module powers
on.
3.
Connect your NeuLog sensors to the side of the WiFi module,
the red LED on each sensor should blink to acknowledge they
are working properly.
4.
Press the button located on the front panel of the WiFi module
three times, the yellow LED labeled „U‟ should turn on.
5.
Open the NeuLog application.
6.
Your connected sensors will automatically be detected.
7.
Once your sensors are detected, you can begin experimenting
in USB mode!
Note: To switch back to Access Point mode from USB mode,
press the button on the WiFi module faceplate three times
again.
be
downloaded
for
free
NEULOG WIFI COMMUNICATION MODULE GUIDE
Troubleshooting walkthrough:
Due to the technological complexity of the NeuLog WiFi-201 module
and the ever updating software and hardware found on today‟s
wireless devices, it is possible that you may run into some
performance issues while the unit is communicating with your
wireless device. Luckily, for these circumstances the NeuLog WiFi
module can easily be cleared and updated!
If you are noticing that the performance of your NeuLog WIFI-201
module is acting sporadic please follow the guides below:
Restarting the WiFi module
at
Restarting the WiFi module will often clear up any connectivity issues
you may be having and is an extremely easy process.
1. Connect the WiFi module to a power source – this can be either
a charged BAT-200 or directly to your computer using the USB
to micro USB cable.
2.
The LED lights on the WiFi module will turn on to indicate that it
is now being powered.
3.
Note: You do NOT need to wait for the network to be transmitted
at this point.
4.
Once the WiFi module is powered, simply press and hold the
button on the front panel of the WiFi module for roughly 4
seconds (until the green, red, and blue turn on).
5.
When the blue LED is the only light on, the closed wireless
network is being transmitted and you can connect devices as
usual.
6.
If the behavior of the WiFi module is still sporadic please
continue to the Updating the WiFi module‟s firmware
walkthrough below.
Advertisement
