Advertisement
7.
Once the sensors are found you will see an icon on the left side
of the screen for any detected sensors. The icon will display
data in real time.
To set the sensors‟ settings click on each sensor‟s icon.
8.
To change the experimental settings click the "Run experiment"
9.
icon (experiment duration for example).
10. To run an experiment and collect data click "Record".
Client mode use:
If you have a wireless network and wish to browse the internet while
using the NeuLog WiFi module; you can use client mode to connect
the WiFi module to your local internet. By default the WiFi module
starts in "Access point mode" but can easily be changed to "Client
mode".
Note: Before following this procedural guide you must configure your
WiFi module using the "Access Point Mode" guide above. Access
point mode is most commonly used.
Configure your WiFi module as per the "Access point mode"
1.
guide in this document.
Using your connected device, locate and click the "Tools" icon
2.
on the top of the NeuLog web application window in your
browser.
Click on "WiFi options"
3.
Input your local internet connection‟s name and password in
4.
their respective text fields and click on "Connect" , This step
attempts to connect the NeuLog WiFi module directly to your
local wireless network allowing you to browse the internet.
Note:
During this time the green light on the WiFi module will flash. In
the event that the NeuLog site could not be accessed the blue
NEULOG WIFI COMMUNICATION MODULE GUIDE
light will turn back on and the WiFi module will return to access
point mode.
5. If connection to the NeuLog site is successful; you will be
disconnected from the NeuLog closed wireless network (i.e.
NeuLog1334) and the green light on the WiFi module will
remain on.
6.
At this point you must connect to your local wireless
connection (the information you put into the "Client Mode"
boxes).
7. On the new screen you get, click the Connect button to
reconnect the bowser to the wifi201 module
8. You will now be in client mode with the ability to browse the
internet using your smart device.
9.
When connecting additional wireless devices (up to 5 total) simply
type the address "Wifi201.com" into your device‟s internet browser
bar. A prompt will ask for the wifi201 ID, this is the digit code located
on the back of the WiFi module. Click "Connect" and now you will be
able to access the NeuLog software broadcast from the WiFi
module.
The next time the WiFi module is turned on it will again attempt to
enter client mode by connecting to the same wireless connection. If
the connection fails; the WiFi module will restart back in access point
mode.
Advertisement
