Opening The Door - AEG LF8E8411A User Manual

24 www.aeg.com
this case, it will be not possible to
guarantee the best washing results.
About 20 minutes after the
program start, the program
duration could be adjusted
again depending on the
capacity of water
absorption of the fabrics.
The ProSense detection is
carried out with complete
washing programs only (no
skipping phase selected).
10.9 Program phase
indicators
When the program starts the indicator of
the running phase flashes and the other
phase indicators are steady on.
E.g. the washing or pre wash phase is
running:
When the phase ends the relevant
indicator stops flashing and is steady on.
The next phase indicator starts flashing.
E.g. the rinse phase is running:
During the washing cycle, the appliance
mixes the detergent, the stain removal
for fabric treatment and/or the fabric
softener with water before introducing
them into the drum; the indicator
appears and disappears on the display
according to the different program
phases (the arrows flash alternatively).
10.10 Interrupting a
program and changing the
options
When the program is running, you can
change only some options:
1. Touch the button Start/Pause.
The related indicator flashes.
2. Change the options. The given
information in the display changes
accordingly.
.
.
3. Touch the button Start/Pause again.
The washing program continues.
10.11 Cancelling a running
program
1. Press the button On/Off to cancel
the program and to deactivate
the appliance.
2. Press the button On/Off again to
activate the appliance.
Now, you can set a new washing
program.
If the ProSense phase is
already carried out and the
water filling is already
started, the new program
starts without repeating
the ProSense phase. The
water and the detergent are
not drained out in order to
avoid waste. The display
shows the maximum duration
of the program, updating it
about 20 minutes after the
starting of the new program.

10.12 Opening the door -

Adding garments
While a program or the delay start
operates, the appliance door is locked.
If the temperature and level
of the water in the drum are
too high and/or the drum
still rotates you cannot open
MIX
the door.
1. Touch the button Start/Pause.
In the display the related door lock
indicator goes off.
2. Open the appliance door. If
necessary, add or remove the items.
3. Close the door and touch the button
Start/Pause.
The program or the delay start
continues.
4. The door can be opened when the
program is complete, or set Spin/
Drain program/option and than
press Start/Pause button.