Advertisement
OPERATING INSTRUCTIONS
Mixing Valve Adjustment
1
of the drink, the mixing valve changes the water to concentrate ratio. This valve is very sensitive. Only slight
rotation of the mixing rod is needed to change the ratio (1/16th to 1/8th of a turn). The factory setting is
approximately 7:1 ratio, which will result in a 5 to 8 percent brix when sweet tea concentrate is used.
NOTICE - Do not rotate the adjusting rod more than 2 full turns from the closed position. More turns will
cause the adjustment rod to disengage from the mixing valve, resulting in a leak.
2
Tilt the dispenser on its side.
3
Before adjusting the mixing valve, check to make sure that the pressure regulator is set to 15 psi. If the
regulator is not properly set, the mixing valve will not work properly. See Setting the Pressure Regulator for
instructions.
4
Locate the adjusting rod (see diagram below). Turn it counter-clockwise (looking from the bottom) for a
stronger concentration – turn clockwise for a weaker concentration. Taste the tea/coffee with each adjustment
to determine the desired consistency.
TCC, OPERATING INSTRUCTIONS
Adjustment
rod
+
-
OI43
030218NC
Advertisement
