Posh P1 Installation Manual

P1/2 install.QX 11/10/04

Installation Guide

P1 & P2
Surface Mount Speakers
Thank you for selecting this Posh
high-performance speaker. Posh has
gained an enviable track record
providing professionals with
audiophile-quality speakers for
commercial and residential installations.
Step 1
Decide whether to mount you speakers vertically or horizontally using the
enclosed U-bracket
Step 2
Unscrew the fastener at the top and bottom of the speaker and
remove the U-bracket.
Step 3
Using the U-bracket mark and drill mounting holes where
you wish to mount your speaker. Attach U-bracket to wall
or ceiling, using appropriate mounting hardware.
NOTE: Construction work for the installation of any Posh
product should be performed by a qualified, licensed installer
and conform to all applicable building codes. A local building
inspector should approve any overhead installations.
Step 4
Strip 3/8 inch off the end of the wire insulation. Connect the speaker wire (posi-
tive + red or white) and (Negative – black or green) to the input terminal located
on the back of the speaker. When daisy chaining multiple speakers, twist the
two stripped ends of the positive wires together and insert into the positive
spring loaded input terminal. Then twist the two stripped ends of the negative
wires together and insert into the negative spring loaded input terminal.
10:23 AM Page 1

Mounting Instructions

Speaker Systems
Sound Solutions for the Real World
Fastener
U-bracket
5
70V
2.5 10
1.25
.0625 1.25
2.5
DO 5
NOT 100V
10
USE