Posh SW-8 Installation Manual

Installation Guide
SW Series Speakers (SW-8/SW-1040)
Contents of carton
(1) fully assembled SW speaker
(1) hardware package containing eyebolts for
the speaker
Before you begin
Please read and understand all of these installa-
tion instructions before beginning any work.
Note that construction work for the installation of
any Posh product must be performed by a quali-
fied, licensed installer and conform with all appli-
cable building codes. A local building inspector
should approve any overhead installations.
Due to the variety of construction materials and meth-
ods you may encounter, the appropriate hanger bolts,
anchor hardware, suspension cable or chain can-
not be supplied by Posh Speaker Systems.
NOTE: This is a down-firing speaker design.
Installation
(new and existing construction)
1. Begin by selecting secure attachment points
using the building's permanent structure to in-
sure the seismic integrity of the installation.
2. Install appropriate hardware in the selected
ceiling location.
3. Attach aircraft cable* or chain securely to the
ceiling hardware.
4. Install the supplied eyebolts on the speaker.
5. Attach the suspension cable to the speaker
eyebolts.
6. If the speaker is 70/100 volt, select the desired
wattage tap by turning the selector switch to
the appropriate setting using a small standard
screwdriver (see illustration).
7. Connect input leads to input terminal.
* Stainless steel aircraft cable and copper cable sleeves
are stocked by TekSupply (www.teksupply.com, 1-800-
835-7877). Minimum recommendation is: CABLE—Part#
AR3010, 1/16", 7x7. SLEEVE—Part# AS1180, 1/16". This
cable carries a 480 ft/lb. breaking strength rating. Work-
ing load rating for this cable is 100 lbs.
POSH SPEAKER SYSTEMS, 7865 NE Day Road West, Building C, Bainbridge Island, WA 98110
Cable sleeves
(not included)
Phone: 800-841-8501 • Fax 206-842-0494 • info@poshspeakers.com
posh
Speaker Systems.
Speaker lead
follows cable
Label shows switch settings
for selecting wattage tap
Eye bolts
(not included)
Suspension cable
(aircraft cable,
not included)
Eye bolts
(4 included)
Input terminal
SWALLI0103