Red-D-Arc EX350ie Operator's Manual page 15

b-2
5. ThERMAL
• This status light indicates when the power source
has been driven into thermal overload. If the out-
put terminals were "ON", the "ON" light will blink
indicating that the output will be turned back on
once the unit cools down to an acceptable temper-
ature level. If the unit was operating in the
"REMOTE" mode, the trigger will need to be
opened before or after the thermal has cleared and
closed after the machine has cooled down to an
acceptable temperature to establish output.
6. CONTROL-REMOTE , LOCAL
• Two status lights indicate the location of output
control as pre-determined by the power sources
auto-configure system.
• The LOCAL display will be lit when control is at the
power source.
• The REMOTE display will be lit when a remote
pot/control is detected.
These Output Control configurations can be over-
ridden (switched) with the CONTROL push button.
When changed, the unit will power up in the config-
uration it was in when it was last powered down.
hidden Middle Control Panel – Process
Set up Panel
The middle control panel is removable to allow for
upgrades (see Field Installed Options/Accessories).
Additionally, this panel is hidden by an access door to
reduce appeared complexity and provide protection to
the controls.
7. WELD MODE SELECT
The Mode Control button selects the following weld-
ing modes desired.
OPERATION
FIGuRE 1
1
5
A A
MPS MPS
6
CONTROL CONTROL
REMOTE REMOTE
LOCAL LOCAL
SELECT SELECT
7
11
12
EX350ie (CE) (RED-D-ARC)
CC-STICK SOFT: The Stick Soft process features
continuous control ranging from 5 to 425 amps. This
mode was intended for most SMAW applications, and
Arc Gouging.
• Arc Gouging: Setting the output of the Stick Soft
mode to 425 amps and/or setting the arc control to
9.5 or above will enable the arc-gouging mode.
The actual output current will depend on the size of
carbon used. The recommended maximum size
carbon is 5/16"(7.9mm).
• The hot Start control regulates the starting current
at arc initiation. hot Start can be adjusted from min-
imum (0), with no additional current added at arc
start, to maximum (10), with double the preset cur-
rent or 425 amps (max of machine) added for the
first second after arc initiation.
• The Arc Control regulates the Arc Force to adjust
the short circuit current. The minimum setting (-10)
will produce a "soft" arc and will produce minimal
spatter. The maximum setting (+10) will produce a
"crisp" arc and will minimize electrode sticking.
CC-STICK CRISP: The Stick Crisp mode features
continuous control from 5 to 425 amps. This mode
was intended primarily for pipe welding applications.
• The hot Start control regulates the starting current
at arc initiation. hot Start can adjust starting current
up or down by 25% of the preset value. The recom-
mended setting for hot Start is 5 where the initial
current is equal to the preset current.
• Arc Gouging: Setting the output of the stick crisp
mode to 425 amps and/or setting the arc control to
9.5 or above will enable the arc-gouging mode. The
actual output current will depend on the size of car-
bon used. The recommended maximum size car-
bon is 5/16"(7.9mm)
2
V V
OLTS OLTS
3
WELD TERMINALS WELD TERMINALS
REMOTE REMOTE
ON ON
OUTPUT OUTPUT
SELECT SELECT 4
8
9
10
b-2