Troubleshooting; Environmental Information - Philips AJ3916/79 User Manual

Troubleshooting

If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or
service center.
WARNING:
stances should you try to repair the set yourself, as this will invalidate the warranty.
No sound.
– Volume not adjusted.
• Adjust the VOLUME.
CD playback does not work.
– CD badly scratched or dirty.
• Replace/ clean CD.
– Laser lens steamed up.
• Wait until lens has adjusted to room temperature
– Laser lens dirty.
• Clean lens by playing a CD lens cleaning disc.
– CD-R is non-finalized.
• Use a finalized CD-R.

Environmental information

All necessary packing material has been omitted to make the packing easy to separate
into 2 categones: cardboard and paper pulp.
Your unit consists of materials which can be recycled if disassembled by a specialized
company. Please observe local regulations on the disposal of packing materials and
old equipment.
CAUTION
Visible and invisible laser radiation. If the cover is open, do not look at the
beam.
High voltage! Do not open.You run the risk of getting an electric shock.The
machine does not contain any user-serviceable parts.
Modification of the product could result in hazardous radiation of EMC or
other unsafe operation.
Do not open the set as there is a risk of electric shock. Under no circum-
Occasional crackling sound during FM
broadcast.
– Weak signal.
• Extend the pigtail antenna fully.
Continuous crackling/ hiss disturbance
during MW broadcast.
– Electrical interference from TVs, computers,
fluorescent lamps, etc.
• Move set away from other electrical equipment
The alarm does not function.
– Alarm time not set.
• See section on Setting alarm time.