CD Clock Radio AJ3916 Register your product and get support at www.philips.com/welcome User manual...
STANDBY-ON A U X...
This Manufacturers Warranty is limited to 3 months for the above listed Consumer Electronics products if used in commercial applications. Philips may, at its discretion choose to replace rather than repair any product covered by this warranty. Product accessories are covered by the same warranty period.
12 months prior to the date of your claim. 5. In the event of a failure, Philips shall be under no liability for any injury, or any loss or damage caused to property or products other than the product under guarantee.
English Congratulations on your purchase and wel- come to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Controls (see 1) 1 REPEAT ALARM/BRIGHTNESS CON- TROL – pushes to switch off alarm for a 9- minute period/changes the brightness of the display illumination.
Clock Setting the clock The clock uses 24-hour time format.You may set the clock from 0:00 if the set is disconnected from the wall outlet. 1 Press and hold MODE until clock digit for hour flashes. 2 Hold down ∞ / § to adjust the hours. 3 Press MODE to confirm the hour setting.
CD Player CD playback This CD clock radio supports audio discs including CD-R (CD-recordable), CD-RW (CD-rewritable). Do not try to play a MP3-CD, CD-ROM, CDI,VCD, DVD or com- puter CD. 1 Press STANDBY-ON to switch on from clock mode. 2 If CD is not selected, press SOURCE once or more to select it.
CD Player ➜ When SHUFFLE mode is selected, the disc will play automatically around few seconds later. 3 To return to normal playback, press MODE repeatedly until the various modes are no longer displayed. – You can also press 9 once to cancel your play modes.
Sleep Sleep About Sleep This set has a built-in sleep timer, which enables - • the gradual turning-down of the volume during playback of CD, Radio or preloaded relaxation music; • the auto switch-off of the set after the desired period of time. Setting and switching off SLEEP 1 Press SLEEP.
Troubleshooting If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service center. WARNING: Do not open the set as there is a risk of electric shock. Under no circum- stances should you try to repair the set yourself, as this will invalidate the warranty.
Meet Philips at the Internet http://www.philips.com CLASS 1 LASER PRODUCT AJ3916 Printed in China Jason 0809...