Using The Alarm; Setting The Alarm - Philips AJ3650/12 User Manual

™ Display shows the radio frequency of the last selected station briefly
before returning to the clock time. Your preset station is also shown if you
are listening to a preset station.
2. Adjust volume by turning VOLUME.
3. Press RADIO to switch off.
Helpful hints:
– When clock time is displayed, to view the current radio frequency,
• Press RADIO twice.
• For preset stations, press the respective PRESET button once or repeatedly.

USING THE ALARM

Two different alarm times can be set. This can be useful when you and your part-
ner need to be woken up at different time. Besides, you can set different alarm
sounds respectively among tuner or sounds of nature.

SETTING THE ALARM

1. Press and hold ALARM 1 until hour digits start flashing.
2. Hold down or press TUNING +/- repeatedly to set the desired hour.
3. Press ALARM 1 to confirm.
™ Minute digits start flashing.
4. Hold down or press TUNING +/- repeatedly to set the desired minute.
5. Press ALARM 1 to confirm.
™
starts flashing.
6. Press TUNING +/- repeatedly to select the desired alarm sound.
7. Press ALARM 1 to confirm.
8. Repeat the steps above but press ALARM 2 instead of ALARM 1 to set the
other alarm.
Helpful hints:
– If you have selected radio as the alarm sound, make sure you have properly tuned
to a station and set the volume before turning off the radio.
– To check the alarm time setting for ALARM 1 or ALARM 2, press ALARM 1 or
ALARM 2.
– It is not possible to adjust the alarm time during an alarm call or alarm repeating mode.