Table of Contents
Advertisement
Symptoms
House fuse is blown, circuit breaker
has tripped, or power outage has
occurred.
Appliance is overloaded.
Clothes take too
long to dry.
Appliance is underloaded.
Heat settings, load size, or
Drying time is
dampness of clothing is not
not consistent.
consistent.
Fabric softener is used incorrectly.
Clean and dirty clothes are being
dried together.
Greasy or dirty
spots are left on
clothes.
Clothes were not properly cleaned
or rinsed before being placed in the
appliance.
Reason
• Reset circuit breaker or replace fuse.
• Divide extra large loads into smaller
• If you are drying a very small load,
• The drying time for a load will vary
• When washing laundry that is to be
• Use the appliance to dry only clean
• Stains on dried clothes could be
Solution
Do not increase fuse capacity. If the
problem is a circuit overload, have it
corrected by a qualified electrician.
loads for better drying performance
and efficiency.
add a few extra items to ensure
proper tumbling action. If the load is
very small and you are using Sensor
Dry programmes, the electronic
control cannot properly sense the
dryness of the load and may shut off
too soon. Use Timed Drying
programmes or add some extra wet
clothes to the load.
depending on the type of heat used
(electric), the size of the load, the
type of fabrics, the wetness of the
clothes, and lint filter. Even an
unbalanced load in the appliance
can cause poor spinning, resulting in
wetter clothes which will take longer
to dry.
dried in the appliance, use the
correct amount of fabric softener as
recommended by the manufacturer
of the fabric softener.
items. Soil from dirty clothes can
transfer to the clean clothes in the
same or later loads.
stains that were not removed during
the washing process. Make sure that
clothes are being completely cleaned
or rinsed according to the
instructions for your washing
machine and detergent. Some
difficult soils may require pre-treating
prior to washing.
EN
33
Advertisement
Table of Contents
