Paradyne FrameSaver 9120 Installation Instructions Manual page 4

Installing a NAM in a 1-Slot Housing
1. Remove the NAM from its shipping box.
2. Carefully align the NAM connectors with the
integrated I/O card/ backplane (rear panel)
connectors. (See Step 3 of Removing a
NAM from a 1-Slot Housing on Page 2
if you need to open the housing first.)
3. Gently, but firmly press the connectors
together until they are fully seated.
Be careful not to force or bend
any pins.
4. Place the NAM and integrated I/O card/ backplane
into the 1-slot housing's base. Make sure the
backplane rests inside the guides on the
base at the rear of the access unit.
5. Place the cover over the base, aligning the four connecting tabs. Make sure the
backplane rests inside the guides on the cover at the rear of the access unit.
6. Press the cover and base together until all four connecting tabs snap into place.
7. Reconnect the power cord/transformer, verifying that the faceplate's OK LED lights
once the self-test is passed.
Refer to the 1-Slot Assembled Access Unit Installation Instructions before
re-installing the cables.
4
496-15046
496-15047
Guide
496-15048