Searching For A Station Frequency Directly; Installation And Connection; Before Installation - JVC KW-M450BT Instruction Manual

Remote Controller Remote Controller
ASPECT Changes the aspect ratio.
• To check the current aspect ratio
setting, operate on the touch panel.
(Page 11)
ENT Confirms selection.
DIRECT Enters direct search mode.
CLR Erases the misentry.
*1 Not applicable for KW-M450BT Australia and New Zealand
models/KW-M450BT Indonesian models.
*2 The search method differs according to the selected seek mode.

Searching for a station frequency directly

While listening to the Tuner, you can search for a
station frequency directly using the number buttons.
1
Press DIRECT to enter the search mode.
2
Press a number button to select a desired
station frequency.
• To erase a misentry, press CLR.
3
Press / to confirm.
To exit the search mode: Press DIRECT.
42 ENGLISH

Installation and Connection

Installation and Connection
WARNINGS
• DO NOT connect the ignition wire (red) and the
battery wire (yellow) to the car chassis (ground), you
may cause a short circuit, that in turn may start a fire.
• DO NOT cut out the fuse from the ignition wire (red)
and the battery wire (yellow). The power supply must
be connected to the wires via the fuse.
• Always connect the ignition wire (red) and the
battery wire (yellow) to the power source running
through the fuse box.
CAUTIONS
• Install this unit in the console of your car.
• Do not touch the metal parts of this unit during and
shortly after the use of the unit. Metal parts such as
the heat sink and enclosure become hot.
• When parking at a low ceiling area, turn off the unit
to store the antenna. As when the unit is installed in
the car with the function of auto antenna; the radio
antenna extends automatically when you turn on
the unit with the antenna control wire (ANT. CONT)
connected. (Page 45)

Before installation

Precautions on installation and connection
• Mounting and wiring this product requires skills and
experience. For best safety, leave the mounting and
wiring work to professionals.
• Mount the unit so that the mounting angle is 30° or
less.
• Make sure to ground the unit to a negative 12 V DC
power supply.
• Do not install the unit in a location exposed to direct
sunlight or excessive heat or humidity. Also avoid
places with too much dust or the possibility of water
splashing.
• Do not use your own screws. Use only the screws
provided. If you use the wrong screws, you could
damage the unit.
• After the unit is installed, check whether the brake
lamps, blinkers, wipers, etc. on the car are working
properly.
• Do not press hard on the panel surface when
installing the unit to the car. Otherwise scratches,
damage, or failure may result.
• If the power is not turned on ("Miswiring DC Offset
Error", "Warning DC Offset Error" is displayed),
the speaker wire may have a short circuit or have
touched the chassis of the car and the protection
function may have been activated. In this case, the
speaker wire should be checked.
• Keep all cables away from heat dissipating metal
parts.