Celect CC816WHB-0-DF Manual

Radio controlled thermostat

Advertisement

Quick Links

CC816WHB-0-DF Radio controlled thermostat
CC816WHB-0-DF is a radio controlled room thermostat which requires no wiring and can be
fitted in any normal operating environment within an open area 100 meter range of the CC2010-DE
receiver.
If the thermostat and the receiver have been supplied together in a combined pack, the units
have been paired in the factory and no commissioning is required.
Power supply ............................................ 2AA Batteries
Radio communication mode ........................Half-duplex
Frequency band
Valid receiving distance
Accuracy........................................ ......... ...±1℃
Room temperature setting range......................5 ~30
Ambient temperature -Operation .....................0 ~+50
Ambient temperature –transport .......................-10 ~60
Dimension ...................................................86×86×32mm(wall mount or 86 box)
(1)
(2)
ON OFF
 Always turn off power at the main power source by unscrewing fuse or switching circuit breaker to

SPECIFICATION

........................
........................100m
KEYBOARD, DISPLAY AND SWITCH DESCRIOPTION
(6)
(7)
(5)
(4)
(3)
ON
OFF
(8)
(10)

IMPORTANT SAFETY INFORMATION:

868MHZ( FSK)
(1) Displayed room temperature or set
temperature
(2) Room temperature icon
(9)
(4) Heating symbol
(5) Error alarm symbol
(6) ℃ symbol
(7) LCD display area
(8) ON/OFF switch
(9) Temperature setting knob
(10) Code learning button
Page 1 of 5

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CC816WHB-0-DF and is the answer not in the manual?

Questions and answers

Summary of Contents for Celect CC816WHB-0-DF

  • Page 1 CC816WHB-0-DF Radio controlled thermostat CC816WHB-0-DF is a radio controlled room thermostat which requires no wiring and can be fitted in any normal operating environment within an open area 100 meter range of the CC2010-DE receiver. If the thermostat and the receiver have been supplied together in a combined pack, the units have been paired in the factory and no commissioning is required.
  • Page 2 the off position before installing, removing, cleaning, or servicing this thermostat.  Read all of the information in this manual before installing this thermostat.  Only a professional contractor should install this thermostat.  All wiring must conform to local and national building and electrical codes and ordinances. ...
  • Page 3 OPERATION Commissioning No commissioning is required when the thermostat and the receiver have been supplied in the combined pack because they have been paired in the factory. User can make commissioning again by following steps for any possible reason. STEP 1: Wire the SAS2010DE receiver, switch off the receiver and hold the power button for 3 seconds until the yellow light is on.
  • Page 4 Display The LCD displays actual room temperature until the setting dial is moved. Setting the temperature Switch on the thermostat , turn setting dial to required temperature. The selected temperature will flash in the LCD to signify it is showing the set temperature. After a short period the display stops flashing and shows actual room temperature.
  • Page 5 CUSTOMER ASSISTANCE After reading this guide, if you have any question about the operation of your thermostat, please contact your installer or Energy Utility company or service provider. Page 5 of 5...

Table of Contents