Advertisement
CC908RF
Easy Bind guide
Important: If you have more than one transmitter you will need to change the DIP Switches near the
batteries on the inside of the thermostat. This will avoid interference between units.
To bind a thermostat to a receiver:
1) Press the learn button on the receiver so that the power light goes out.
2) Press and hold the learn button until the learn light lights
4) Insert the batteries into the transmitter and close the unit
5) The learn light on the receiver will flash a few times and go out
6) Press the learn button again so that the power light comes on
7) The transmitter and receiver are now bound.
The on light should come on when the transmitter is calling for heat (flashing flame), and go off
when the room is up to temperature (solid flame). Ensure the ON/OFF override button on the
receiver is in the off position for it to work on the thermostat. It can be pressed into the on position
to bring the heater on in the event of communication failure.
Advertisement
Table of Contents
Related Manuals for Celect 908
Summary of Contents for Celect 908
- Page 1 CC908RF Easy Bind guide Important: If you have more than one transmitter you will need to change the DIP Switches near the batteries on the inside of the thermostat. This will avoid interference between units. To bind a thermostat to a receiver: 1) Press the learn button on the receiver so that the power light goes out.
- Page 2 CC908 Quick Programming Guide Instead of programming on and off times you programme temperatures. This allows you to have different temperatures throughout the day, for example, a warmer temperature in the morning to the evening. When the heating is not needed, use a low temperature (for example 5C) this will protect your building from frost.
Need help?
Do you have a question about the 908 and is the answer not in the manual?
Questions and answers