Toro 138-2998 Installation Instructions page 4

1. Positive-post clamp
2. Negative-post clamp
3. Nut
3. Remove the nuts from the post bolts
4. Install the positive-terminal connector (red wire)
over the positive-post bolt and loosely install the
nut (Figure 5).
5. Install the negative-terminal connector (black
wire) over the negative-post bolt and loosely
install the nut (Figure
6. Install the positive-post clamp to the
positive-battery post and then the negative-post
clamp to the negative-battery post
7. Use the cable ties to secure the wire harness
to the frame.
Note:
Do not secure the wire harness to hot or
moving parts.
Connecting to the Cab Harness
1. Route the harness along the right side of the
frame.
2. Connect the harness to the cab harness
6).
Figure 5
4. Ring connector
5. Bolt
(Figure
5).
(Figure
Figure 6
g032519
5).
5).
(Figure
g253357
4