Advertisement
4
Routing the Wire Harness
No Parts Required
Installing the Wire Harness
Important:
Whenever working with the electrical
system, always disconnect the battery cables,
black (-) cable first, to prevent possible wiring
damage from short-outs.
1.
Route the wire harness on the right side of the
machine frame
(Figure
1. Battery terminals
2. Washer connector
3. Fuse (60 A)
4. Fuse (10 A)
2.
Remove the nut that secures the positive-battery
clamp to the positive-battery terminal.
3.
Attach the positive battery terminal from the wire
harness to the bolt used to secure the battery
clamp.
4.
Secure the clamp with the nut you removed
previously.
5.
Repeat the previous steps for the negative
battery terminal on the wire harness.
3).
Figure 3
5. Relay connector
6. Cab connectors
7. Cab power connector
Connecting the Washer Bottle
1.
Connect the plug into the washer bottle
4).
1. Washer connector
2.
Use the cable ties to secure the wire harness
to the frame.
Note:
Do not secure the wire harness to hot or
moving parts.
g030435
Connecting the Battery
1.
Route the 10-gauge red and black wires along
the ROPS tube on the left side of the frame and
toward the battery
2.
Loosen and remove the negative-post clamp
and then the positive-post clamp from the
battery
(Figure
3
Figure 4
2. Washer-bottle connection
(Figure
5).
5).
(Figure
g032522
Advertisement
