Dmx Mode; Set The Starting Dmx Address; Select The Dmx Channel Mode; Dmx512 And Art-Net Mode - Blizzard Lighting Stiletto Beast Manual

DMX Mode

Allows the unit to be controlled by any universal DMX controller.

Set the Starting DMX Address:

1.) Navigate the main menu until you reach Address, press <ENTER>.
2.) Use the <UP/DOWN> buttons to select a DMX channel from 001-512.
3.) Press the <ENTER> button to confirm.

Select the DMX Channel Mode:

1.) Navigate the main menu until you reach User Mode, press <ENTER>.
2.) Use the <UP/DOWN> buttons to select Standard (26CH), Extended RGBW
(45CH) or Extended (54CH).
3.) Press the <ENTER> button to confirm your selection.

DMX512 and Art-Net Mode:

1.) Navigate the main menu until you reach Intro, press <ENTER>.
2.) Use the <UP/DOWN> buttons to select DMX512, or Artnet.
3.) When DMX512 is selected, signal can be sent/received through the 3/5-pin
DMX connections, and when Artnet is selected, signals can be sent/recieved
through the RJ45 connections.

Slave Mode:

1.) Navigate the main menu until you reach Intro, press <ENTER>.
2.) Use the <UP/DOWN> buttons to select Slave.
3.) Press the <ENTER> button to confirm.
Auto, Sound Active, & Manual Adjustments:
Allows a single or Master/Slaved units to run factory installed programs.

Auto Mode:

1.) Navigate the main menu until you reach Intro, press <ENTER>.
2.) Use the <UP/DOWN> buttons to select Auto1 or Auto2.
3.) When using either auto run mode, the unit can be used as a master fixture
with other linked fixtures that are set to Slave.

Sound Active Mode:

1.) Navigate the main menu until you reach Intro, press <ENTER>.
2.) Use the <UP/DOWN> buttons to select Sound1 or Sound2.
3.) When using either sound active mode, the unit can be used as a Master fixture
with other linked fixtures that are set to Slave.

Static Mode:

1.) Navigate the main menu until you reach Intro, press <ENTER>.
2.) Use the <UP/DOWN> buttons to select Static.
3.) When Static is enabled, manual 0-255 adjustments found in Intro > Static
are active. These are the same settings found in 26CH Standard DMX mode.

Calibration Settings:

1.) Navigate to Intro <ENTER>, then Calibration <ENTER>.
2.) Use the password 033 to enable editing of the values within for Pan, Tilt, Zoom,
and Zoom (Lens) Rotation 0-255.
3.) Press the <ENTER> button to confirm.
Stiletto Beast™ User Manual - Rev. A
Page 12
(c) 2016 Blizzard Lighting, LLC