Multipoint Pairing; Moisture Detected Alert - Aftershokz Aeropex User Manual

Multipoint Pairing

Multipoint pairing allows Aeropex to be connected to two devices at once,
allowing users to seamlessly transition between the two.
1. Start with your headphones powered off.
2. Press and hold volume+ until Audrey says "pairing" and the LED indicator flashes
red and blue.
3. Press and hold the multifunction button and volume+ button for 3 seconds.
Audrey says "multipoint enabled."
4. Open your first device's Bluetooth
Audrey says "connected".
5. Turn your headphones off.
6. Re-enter pairing mode by pressing and holding volume+ until Audrey says "pairing"
and the LED indicator flashes red and blue.
7. Open your second device's Bluetooth
Audrey says "connected."
8. Turn your headphones off.
9. Turn your headphones on. Your headphones are now connected to both devices.
10.To turn multipoint pairing off: Press and hold the multifunction button and volume-
button for 3 seconds. Audrey says "multipoint disabled."
More information: bit.ly/ASMultipoint

Moisture Detected Alert

These headphones can detect liquid such as water, sweat, and rain. If the headphones are
plugged into the charger while wet, the LED indicator will flash red and blue. The headphones will
also vibrate and emit a beep. If this happens, remove the charging cable from the headphones, dry
them completely and then proceed with charging.
menu and select "Aeropex by AfterShokz."
®
menu and select "Aeropex by AfterShokz."
®
11