Peavey TRANSTUBE Series Manual page 5

POWER AMP SECTION
Rated Power and Load:
15 W RMS into 4 ohms
Power @ Glipping (Typically):
(5% THD, 1 kHz, 120 V AC line)
15 W RMS into 4 ohms
Total Harmonic Distortion:
Less than 0.5%, 100 mW to
10 W RMS, 60 Hz to 10 kHz,
4 ohms (typically below 0.2%)
Power Consumption:
40 W. 50/60 Hz. 120 V AC
PREAMP SECTION
The following specs are
measured @ 2 kHz with the
controls preset as follows:
Channel Select Normal (Out)
Low and High @ 10
RAGE@ 1s8/BLAZER@ 158
SPECIFICATIONS
M i d @ 0
Pre Gain and Post Gain @ 10
Reverb @ 0
Nominal Levels are with Nominal
Gain @ 5.
Minimum Levels are with Normal
Gain @ 10.
Preamp Input (Normal Ghannel):
lmpedance: High Z, 1 M ohm
Nominal Input Level: -6 dBV
70 mV RMS
Maximum Input Level:
O d B V I V R M S
CD/Tape Input:
lnput lmpedance: 100 k ohms
Nominal Input Level: .5 V RMS,
-6 dBV
(Stereo jack designed for use with
stereo headphone outputs on
CD/tape players)
Headphone Output:
Load lmpedance: 4 ohms
or grealer
Nominal Power Output:
20 mW into 4 ohms
(Stereo jacks, monaural
signal disconnects internal speaker
when phone plug
is inserted.)
System Hum and Noise @
Nominal Input Level:
(2O Hz to 20 kHz unweighted)
62 dB below rated power
Equalization:
Special low, mid, and high
passive type EQ
Specifications subiect to change without notice,
HIGH GAIN
AMP
RAGE@ 1s8/BLAZER@ 158
BLOCK DIAGRAM
REVERB LEVEL
4 oHtvl
SPEAKER
This block diagram shows signal flow within the unit. In order to throughly
understand the unit's functions, please study the block diagram carefully.