Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Master VT D Series
Summary of Contents for Master VT D Series
- Page 1 VT Service Manual -D Series Models: VT-751D, VT-752D...
- Page 2 OTHER MANUFACTURERS ARE NOT PRODUCED TO THESE PRECISE SPECIFICATIONS. FAILURE TO USE MASTER APPLIANCE REPLACEMENT PARTS OR FAILURE TO INSTALL MASTER APPLIANCE REPLACEMENT PARTS EXACTLY AS INSTRUCTED MAY CAUSE PHYSICAL INJURY OR DAMAGE TO THE HEAT GUN. MASTER APPLIANCE CANNOT ASSUME RESPONSIBILITY FOR PHYSICAL INJURY OR DAMAGE TO THE HEAT GUN RESULTING FROM THE USE OF ANY OTHER BRAND OF REPLACEMENT PART OR IMPROPER INSTALLATION OF MASTER APPLIANCE REPLACEMENT PARTS OR ACCESSORIES.
- Page 3 #6-32 x .50, QTY 2 SPRING Ⓔ SUPPORT Ⓕ BOLT, HEX, STEM, KNURLED #6-32 SCREW, M3x0.5 Ⓚ x 10mm long, ATTACHED TO MOTOR FRAME Master Appliance Corp. Tel: 262-633-7791 www.masterappliance.com 2420 18 Email: sales@masterappliance.com 58279E REV A Racine, WI 53403-2381 pg. 2 of 7...
- Page 4 Disconnect the terminals . (Figure 5). Ⓝ Disconnect the circuit board from the switch (Figure 5). CIRCUIT BOARD Remove the circuit board. Master Appliance Corp. Tel: 262-633-7791 www.masterappliance.com 2420 18 Email: sales@masterappliance.com 58279E REV A Racine, WI 53403-2381 pg. 3 of 7...
- Page 5 WARNING: Failure to cover the terminals with shrink tubing could result in electrical short Master Appliance Corp. Tel: 262-633-7791 www.masterappliance.com 2420 18 Email: sales@masterappliance.com...
- Page 6 WIRES BETWEEN METAL HANDEL HANDLES CORD CLAMP BETWEEN CORDSET AND METAL HOUSING, ONLY USED ON EUROPEAN, U.K., AND 220-240V CORDSETS Master Appliance Corp. Tel: 262-633-7791 www.masterappliance.com 2420 18 Email: sales@masterappliance.com 58279E REV A Racine, WI 53403-2381 pg. 5 of 7...
- Page 7 AFTER HEAT GUN IS COMPLETELY ASSEMBLED, CONDUCT New mica FINAL ADJUSTMENT AND TEST: Roll mica over coils of Plug your Master Heat Gun® into a properly rated electrical element outlet. Run in “Cool” mode, gently tap bottom of unit to align motor bearings unit until motor noise stabiles.
-
Page 8: Troubleshooting Guide
Remove dial and ensure wave spring is present, Dial is loose Wave spring not installed reinstall dial Master Appliance Corp. Tel: 262-633-7791 www.masterappliance.com 2420 18 Email: sales@masterappliance.com 58279E REV A Racine, WI 53403-2381 pg. 7 of 7...
Need help?
Do you have a question about the VT D Series and is the answer not in the manual?
Questions and answers