Page 1
HG Service Manual-D SERIES Models: HG-201D, HG-202D, HG-301D, HG-302D, HG-501D, HG-502D, HG-801D...
Page 2
OTHER MANUFACTURERS ARE NOT PRODUCED TO THESE PRECISE SPECIFICATIONS. FAILURE TO USE MASTER APPLIANCE REPLACEMENT PARTS OR FAILURE TO INSTALL MASTER APPLIANCE REPLACEMENT PARTS EXACTLY AS INSTRUCTED MAY CAUSE PHYSICAL INJURY OR DAMAGE TO THE HEAT GUN. MASTER APPLIANCE CANNOT ASSUME RESPONSIBILITY FOR PHYSICAL INJURY OR DAMAGE TO THE HEAT GUN RESULTING FROM THE USE OF ANY OTHER BRAND OF REPLACEMENT PART OR IMPROPER INSTALLATION OF MASTER APPLIANCE REPLACEMENT PARTS OR ACCESSORIES.
Page 3
SHIELD Ⓖ BEZEL / SWITCH / JUMPER SCREW, M3x0.5 Ⓚ x 10mm long, Ⓙ HANDLE SCREWS (4) UNDER MODEL LABEL Master Appliance Corp. Tel: 262-633-7791 www.masterappliance.com 2420 18 Email: sales@masterappliance.com 58278E REV A Racine, WI 53403-2381 pg. 2 of 6...
Page 4
(Figure 3). Lift the cable guard out of the handle and remove the cordset. GREEN WIRE AND GREEN SCREW TABS IN HANDLE Master Appliance Corp. Tel: 262-633-7791 www.masterappliance.com 2420 18 Email: sales@masterappliance.com 58278E REV A Racine, WI 53403-2381 pg.
Page 5
Connect the wires to the appropriate switch terminals per instructions above (Figure 8). The black jumper wire is to wrap around the white wires from the motor and element connector, and the green wire from the cordset. Master Appliance Corp. Tel: 262-633-7791 www.masterappliance.com 2420 18 Email: sales@masterappliance.com...
Page 6
AFTER HEAT GUN IS COMPLETELY ASSEMBLED, CONDUCT New element FINAL ADJUSTMENT AND TEST: Ⓦ Plug your Master heat gun® into a properly rated electrical outlet. Figure 12 Run in cool mode, gently tap bottom of unit to align motor Element bearings unit until motor noise stabiles.
Element connector or switch not wired Ensure element connector and switch are wired correctly properly Switch damaged Test switch and replace if defective Master Appliance Corp. Tel: 262-633-7791 www.masterappliance.com 2420 18 Email: sales@masterappliance.com 58278E REV A Racine, WI 53403-2381...
This manual is also suitable for:
Hg-201dHg-301dHg-302dHg-501dHg-202dHg-502d...
Show all
Need help?
Do you have a question about the HG D Series and is the answer not in the manual?
Questions and answers