Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for PRODIS NT Series
Summary of Contents for PRODIS NT Series
- Page 1 NT1SLIM-HC - NT1BH-HC - NT1BHSP-HC - NT1BHLO-HC - NT1ST-HC - NT2BH-HC - NT2BHLO-HC - NT2BS-HC NT2BSLO-HC - NT2ST-HC - NT3BH-HC - NT3BS-HC - NT3ST-HC - NT10-HC - NT10ST-HC - NT20-HC - NT20ST-HC NT SERIES BACK BAR REFRIGERATION USER MANUAL NT100818UM Rev 1.1...
- Page 2 PART I TABLE OF CONTENTS PART I - WARNINGS PART II - INSTALLATION PART III - OPERATING INSTRUCTIONS PART IV - MAINTENANCE AND CLEANING PART V - TROUBLESHOOTING IMPORTANT 13. IT IS THE USERS RESPONSIBILITY TO ENSURE THE ONGOING MAINTENANCE OF THE REFRIGERATOR IS 01.
- Page 3 PART II LEVELLING THE REFRIGERATOR 01. UNPACKING 01. CARE SHOULD BE TAKEN TO ENSURE THE WARNING REFRIGERATOR IS PERFECTLY LEVEL FOR CORRECT OPERATION. A SPIRIT LEVEL SHOULD BE USED TO CHECK KEEP ALL PACKAGING MATERIALS INCLUDING BOXES, THE UNIT IS PERFECTLY LEVEL, IF THE UNIT IS NOT LEVEL PLASTIC BAGS AND POLYTHENE OUT OF REACH OF WATER LEAKS MAY OCCUR.
- Page 4 PART III TO CHANGE THE SET POINT OF YOUR COOLER PRESS THE WARNING SET BUTTON FOR 3 SECONDS UNTIL ST IS DISPLAYED IN THE DISPLAY. WITH ST SHOWING IN THE DISPLAY PRESS IF THE POWER SUPPLY CABLE IS DAMAGED, DO NOT THE SET KEY AGAIN, THE CURRENT SET POINT IS NOW INSTALL OR OPERATE THE MACHINE UNTIL THE CABLE DISPLAYED ON THE CONTROLLER.
- Page 5 PART III PART IV LOADING YOUR CABINET THE CABINET IS SUITABLE FOR USE IN CONDITIONS UP TO 55% RELATIVE HUMIDITY. CONDITIONS ABOVE THE RATED ALLOW YOUR CABINET TO RUN FOR 2 HOURS AFTER VALUE WILL CAUSE EXCESS FROST AND ICE BUILD UP INSTALLATION BEFORE LOADING PRODUCTS INTO THE WHICH WILL AFFECT THE PERFORMANCE AND EFFICIENCY REFRIGERATOR.
- Page 6 PART IV PREPARING YOUR REFRIGERATOR FOR LONG TERM WARNING STORAGE OR MOVING NEVER CLEAN THE REFRIGERATOR WITH A PRESSURE IF THE REFRIGERATOR NEEDS TO BE STORED FOR A LONG WASHER OR BY SPRAYING WATER. PERIOD OF TIME OR IT NEEDS TO BE MOVED TO A NEW LOCATION THE FOLLOWING STEPS MUST BE TAKEN WARNING NEVER USE ACIDIC OR ABRASIVE DETERGENTS, THESE...
-
Page 7: Troubleshooting
PART V TROUBLESHOOTING SYMPTOM POSSIBLE CAUSE SUGGESTED SOLUTION UNIT IS NOT CONNECTED • CHECK POWER IS ON AT THE SOCKET TO MAINS ELECTRICITY • CHECK CABLE IS CORRECTLY PLUGGED IN CORRECTLY MACHINE IS SWITCHED OFF • PRESS POWER ON/OFF BUTTON (WHERE FITTED) UNIT WILL NOT SWITCH ON FUSE BLOWN OR CIRCUIT • CHECK FUSE IN MAIN 13AMP PLUG... - Page 8 PROJECT DISTRIBUTION LTD UNIT 1 SUN STREET STOKE-ON-TRENT UNITED KINGDOM ST1 4JW TEL: 01782 280289 SALES@PROJECT-DISTRIBUTION.CO.UK WWW.PRODIS.CO.UK NT100818UM Rev 1.1...
Need help?
Do you have a question about the NT Series and is the answer not in the manual?
Questions and answers