Advertisement
6.3.
A word about the extra cables: You will need to play with the excess cable to
be sure that the excess cable is in front of or on top of the drives—and not below the
drives. Ideally, you will have the excess gray cable folded on top of the drives and the
power cable tucked in in front of the fan housing.
6.4.
Once the two pins are in the blue grommets, align the left side of the drive
bay so that it is directly over the screw holes on the left side of the TiVo.
6.5.
Screw the two screws (and gold inserts) back into the holes on the left side
of the drive bay using the Torx screwdriver.
6.6.
Insert the fan cable back into the motherboard. (This is easy to
forget, which is why it is in bold!)
7. RE-ATTACHING THE TIVO LID
7.1.
Kneel down in front of your TiVo as you did when you removed the lid. Place
the TiVo lid back over the TiVo. Align the clips on each side of the lid so that they clip
down on the sides of your TiVo. Slide the lid toward you while simultaneously pushing
down on the top of the lid.
7.2.
Once the lid is in place, reattach the four Torx screws.
7.3.
Plug in your TiVo and enjoy! NOTE: When you first power up your TiVo, you
may find that the TiVo restarts itself once at the "Powering up..." screen. This is normal
and will happen only once.
We thank you very much for your purchase and hope that you enjoy your newly-enhanced
TiVo. Please
email us
upgrade easy to install (or even if you found it more difficult than you expected), we'd
love to know. If you found our service to be excellent (or awful), we want to know that
too. We're always looking to improve our products and services...the more we hear from
you, the better. Thanks very much!
with any comments, suggestions or complaints. If you found the
http://www.weaknees.com/
WeaKnees.com
Advertisement
