Troubleshooting; Cleaning The Spray Arm; Frost Precautions - Moulinex studio MINID2SL Instruction Manual

Cleaning the Spray Arm

The spray arm can be easily
removed for periodic cleaning of
the nozzles to prevent possible
clogging.
To remove the spray arm, hold and pull it out.
Wash the spray arm under running water and
attach it back in place, checking that the rotary
movement is in no way impeded.

Frost Precautions

Avoid placing the dishwasher in a location where
the temperature is below 0°C. If this is unavoidable,
empty the dishwasher, close the door, disconnect
the water inlet pipe and empty it.

TROUBLESHOOTING

Problem
Fuse blown, or the
circuit breaker
tripped
Dishwasher Power supply is not
will not start. turned on.
The door has not
been properly
closed.
Kink in drain hose
Filter clogged
Water not
pumped from
dishwasher
Kitchen sink clogged
Possible Causes Solutions
Replace fuse or reset circuit breaker.
Remove any other appliance sharing the
same circuit with the dishwasher.
Make sure the dishwasher is turned on
and the door is closed securely.
Make sure the power cord is properly
plugged into the wall socket.
Close the door securely.
Check drain hose.
Check the filters (see "Cleaning the
Filters").
Check kitchen sink to make sure it is
draining well. If kitchen sink is not
draining, you may ask a plumber to
check it.
EN-15